Cardin Elettronica 500 Mode D'emploi page 19

3
8
• Remove the keypad base "8". Remove the battery "9" and insert the battery connector "10" into its slot. Insert the battery
"11" and check for correct connection : pressing any key will activate the green LED and the keypad will sound a
beep. Replace the keypad base "12" and fasten down using the six previously removed screws "13".
14
15
• Rotate the keypad, hook it onto the upper part of the keypad base " 14 " and rotating it slightly allow it to snap onto the
base " 15 " then fasten the keypad using the two supplied screws "16" screwing them into the bottom.
9
10
Attention: The battery charge level can be checked
by pressing any key when you are in the fuction mode:
- if the red LED lights up the battery is not fully charged.
Battery replacement
Obtain a 3V battery pack Cardin Code Nr. ZRA3.0-3.8-W.
Follow steps 9, 10 and 11, fig. 3 to replace the battery
16
and carry out the charge test.
19
13
11
12