Duux Beam mini Manuel D'utilisation page 6

Mode button
button to active/deactivate the auto mode
Use the
or set a timer.
Press the button to cycle through the modes:
Auto mode and Timer mode.
The selected mode icon will illuminate on the display.
Use the and buttons to change the setting. To
confirm the changes, wait for ± 3 seconds or press
the button again.
Note: If the display shows , the chosen
mode won't activate or will be deactivated after
confirmation.
For more information on functions, see
chapter
Functions.
/ Increase/decrease button
The behaviour of the increase / decrease buttons
depends on the mode that is being set.
Manual mode: Increase or decrease mist output
•
level.
Auto mode: Increase or decrease the desired
•
relative humidity level.
Timer mode: Increase or decrease the timer
•
with 1 hour increments.
10
Functions
Manual mode
In Manual mode users can select the desired mist
output.
Use the and buttons to select the desired
mist output. The mist output level bars will change
accordingly. There are three mist output levels:
Low
Medium
High
Auto mode
In
Auto mode users can set the built-in hygrostat
to their desired relative humidity level. If the ambient
relative humidity drops below the desired level, the
mist output will automatically turn on. It will continue
to operate in the chosen mist output level until the
hygrostat level is reached.
Before turning on Auto mode, select the desired
mist output level in Manual mode using the
and
buttons. Press the button until the indicator
illuminates on the display. Press the
and
buttons to set the hygrostat to the desired relative
humidity level.
Note: The mist output level can't be changed when
the mode is active.
The desired relative humidity level can be set between
40% and 90% with increments of 5%. When you go
below 40% or above 90%, the display will show
and Auto mode will be deactivated. The following
sequence shows the steps and how they cycle.
> 40% > 45% > 50% > [...] > 90% > >40%
Timer
Press the button until the indicator illuminates
on the display. Use the
and buttons to
increase or decrease the timer hours in the following
sequence: 1h > 2h > 4h > 8h > OFF.
Once the timer is activated, the device will
automatically shut down after the set timer has been
completed.
Display brightness
The display will automatically dim after the last touch
or press.
Refill water indicator
When the water level becomes too low to produce
mist, the device will make three "beep"-sounds
and the display will show the red
indicator in
combination with an E1 notification. Please follow the
steps explained in Filling the water tank. When the
water tank is refilled you may plug in the power cord
and turn on the device.
Display notifications
The following notification may show on the display:
• E1: The water level in the mist chamber is too
low to produce mist.
is not placed on the
• E2: The water tank
humidifier base
.
E3: If this notification shows, please contact your
•
nearest service provider.
11