Campingaz Plancha Mode D'emploi page 13

R. ELECTRICAL AND ELECTRONIC wASTE
This symbol means that the appliance's electrical
system must be disposed of selectively. At the end of
its life, the appliance's electrical system must be
scrapped correctly. The electrical system must not be
disposed of with unsorted municipal waste. Selective
collection of waste promotes reuse, recycling or other forms of
recovery of recyclable materials contained in this waste. Take
the appliance's electrical system to a waste recovery centre
designed for the purpose (waste collection point). Check with
your local authorities. Never dispose of in nature, do not
incinerate: the presence of certain hazardous substances in
electrical and electronic equipment can be harmful to the
environment, and have a potential effect on human health.
S. TROuBLESHOOTING
Problems
The burner will not light
Burner 'pops' or blows
itself out
Sputtering unsteady flames
GB
Large flames on surface
of burner
Flame low on jet
Burners light with a match,
but not with the "PIEZO"
igniter
Fire at any connection
Lack of heat
Fire behind control knob
Fire under control panel
Probable causes / remedies
y Lack of gas supply.
y Regulator does not work.
y Hose, valve, Venturi tube or burner openings are blocked.
y Venturi tube not seated over jet.
y Check gas supply.
y Check hose connections.
y Contact the After Sales Service.
y New bottle may contain air. Continue use and the problem will disappear.
y Contact the After Sales Service.
y Jet nozzle badly connected to Venturi tube. Adjust the Venturi tube. (Fig. 5 & 6 )
y The Venturi tube is clogged (e.g.: cobwebs). Clean Venturi tube.(Fig. 5 & 6 )
y Contact the After Sales Service.
y The bottle is almost empty. Change bottle and the problem will disappear.
y Contact the After Sales Service.
y Faulty igniter button, wire or electrode. Check igniter cable connections.
y Check condition of electrode and connection wire.
y Contact the After Sales Service.
y Leaking connection.
y Turn off gas supply immediately.
y Contact the After Sales Service.
y Clogged jet or Venturi tube. (Fig. 5 & 6 )
y Contact the After Sales Service.
y Defective valve.
y Turn off appliance.
y Contact the After Sales Service.
y Turn off appliance.
y Close gas cylinder.
y Contact the After Sales Service.
12