Installation - Booster Without Backrest - Harmony DEFENDER 360 Manuel D'instructions

INSTALLATION - BOOSTER WITHOUT BACKREST

See "Assembling/disassembling
for instructions for removing the backrest. Once
backrest is removed, turn recline knob clockwise until
end is reached to retract the base plate on the bottom
of the seat.
1. Place the booster seat flush against a forward-facing
vehicle seat. The vehicle seat MUST be equipped with
a 3-point lap-and-shoulder belt. Booster must be
level, stable and not rock side-to-side (see "Vehicle
seating positions").
2. Place child on the booster seat with child's back flat
against the vehicle seat.
3. Thread both sides
of the
under BOTH armrests.
Thread
end of the shoulder
belt under the armrest on the
buckle side ❶. ENSURE that
the belt is snug across the child's
hips. It is important to ensure that any lap strap is
worn low down, so that the pelvis is firmly engaged,
just touching their thighs and is NOT across their
stomach.
4. Buckle the vehicle seat belt into place and ensure it is
secure by gently pulling on it.
! BOTH SIDES OF THE LAP BELT MUST PASS UNDER
BOTH ARMRESTS, AND THE LOWER END OF THE
SHOULDER BELT MUST PASS UNDER THE ARMREST
ON THE BUCKLE SIDE.
!
Any straps holding the restraint to the vehicle should
be tight, any straps restraining the child should be
adjusted to the child's body, and all straps should not
be twisted.
! NEVER USE A VEHICLE LAP-ONLY BELT WHEN USING
THIS BOOSTER SEAT.
lap belt
the lower
child restraint"
❶
42