Care And Cleaning - Domo DO9013W Mode D'emploi

DO9013W
5. The kettle will not re-boil until the switch is uplifted. Allow to cool for 15~20
seconds before reopening to boil water. The kettle may be stored on the power
base when not in use.
NOTE: Ensure that the power supply is turned off when the kettle is not in use.
Should you accidentally allow the kettle to operate without water, the boil-dry
protection will automatically switch it off. If this should occur, allow the kettle to
cool before filling with cold water and re-boiling.

CARE AND CLEANING

Always disconnect the appliance from the power outlet before cleaning.
Never immerse the kettle area or cord in water, or allow moisture to contact with these
parts.
Removal of mineral deposits
Mineral deposits in tap water may cause the kettle interior to discolor. To remove this
build-up, use Liquid Descaler, a simple to use, non-toxic cleaner.
Alternatively:
Fill the kettle with 3 cups of white vinegar and the remainder with water and let it rest
overnight. DO NOT BOIL
Empty the solution from the kettle. Any stains remaining inside the spout can be
removed by rubbing with a damp cloth. Fill the kettle with clean water, bring to the
boil and then discard the water. Repeat and the kettle will then be ready to use.The
outside of the kettle can be wiped with a damp cloth.
Cleaning appearance of housing
Wipe the appearance of housing with a wild and damp cloth or cleaner, never use a
poisonous cleaner.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the
outside of the kettle.
26