Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION
1. Lid
2. Spout
3. Water gauge
4. Indicating light
5. Power base
6. Handle
7. On/off switch
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you clean your
kettle before use by boiling a full kettle of water twice and then discarding the water.
OPERATION OF YOUR KETTLE
1. To fill the water kettle, remove it from the power base and open the lid by
pressing the "Open lid" button. Fill with the desired amount of water. Always fill
the kettle between the minimum (0.5L) and maximum (1.7L) marks. Too little
water will result in the kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of
the spout when boiling. Ensure that the lid is firmly in place before connecting the
power cord to the outlet.
2.
Position the kettle on the power base.
3. Connect the plug into a power outlet. Press the switch button below the handle.
The indicating light will light up. Then start to boil the water. The kettle will
switch off automatically once the water has boiled. You can shut off the power by
pressing the switch button at any moment during boiling water.
NOTE: Ensure that the switch is clear of obstructions and the lid is firmly closed.
The kettle will not turn off if the switch is constrained or if the lid is left open.
4. Lift the kettle from the power base and then pour the water.
NOTE: operate carefully when pouring the water from your kettle, as boiling
water will scald.
1
2
3
25
6
4 - 7
5
DO9013W
Publicité
Table des Matières
