Ryobi RY120350 Manuel D'utilisation page 9

STARTING AND STOPPING THE POWER
CLEANER
See Figure 8.
WARNING:
Hold the power cleaner securely with both hands. Expect
the power cleaner to move when the trigger is pulled due
to reaction forces. Failure to do so could cause loss of
control and injury to yourself and others.
NOTE: Never place or immerse the unit in standing water.
To start:
Connect the garden hose or submerge filtered end of

siphon hose into water source.
Install the battery pack.

Place the lock-out button in the unlocked position.

Squeeze and hold the trigger to operate.

Start with the nozzle 1–2 ft. away from the cleaning surface
and carefully approach the surface just until the desired
level of cleaning is achieved. If the spray is too close it can
damage the cleaning surface.
To stop:
Release the trigger to stop the flow of water through the

nozzle.
Place the lock-out button in the locked position.

Remove the battery pack.

OPERATION
SELECTING THE RIGHT NOZZLE FOR THE
JOB
See Figure 9.
Each of the nozzles has a different spray pattern. Before
starting any cleaning job, determine the best nozzle for the
job. Refer to the Nozzle Selection Guide for more information.
Rotate the nozzle until the desired position is selected.
TURBO
RINSING WITH THE POWER CLEANER
See Figure 10.
Turn off the power cleaner and shut off the water supply.

Engage the lock out on the trigger by moving the lock-out

button to the locked position.
Rotate the 3-in-1 nozzle to the desired position of the

three nozzles.
Select the right nozzle for the job. See the chart shown

earlier in the manual to select the appropriate nozzle.
Start at the top of the area to be rinsed and work down,

overlapping the strokes.
9 — English
NOZZLE SELECTION GUIDE
15˚ RINSE