WASH
The washer will fill to the correct water level based on the
load size and the Water Level selection. Certain cycles may
agitate during the fill process to boost cleaning. You will
hear the agitator rotate followed by a pause lasting several
seconds. When the wash cycle begins, you will hear the
agitator increase speed. The motor sounds may change at
different stages in the wash cycle while the washer performs
different wash actions.
RINSE
Certain cycles use a spray rinse, which adds water to the tub
while the basket spins. You will hear sounds similar to the
wash cycle as the washer rinses and moves the load. You
may hear the motor turning on briefly (short hum) to move the
basket while filling.
SPIN
The washer spins the load at increasing speeds for proper
water removal based on the selected cycle and spin speed.
DONE
Once the cycle is complete, this light will come on. For best
results, promptly remove the load.
LID LOCKED
The Lock feature allows for higher spin
speeds. When lit, the lid is locked and
cannot be opened without pausing the
cycle. When the light is off, the lid can
be opened.
To open the lid after it has been locked, press START/
PAUSE. The lid will unlock once the washer movement
has stopped. This may take several minutes if the load
was spinning at high speed. Press START/PAUSE while
the lid is closed to resume the cycle.
5