Parallel Stopper; Installation And Setting - MeisterCraft LASER MPS 800 EL Traduction Du Manuel D'utilisation Original

MC-5453380-Bediene-0110.qxd
Safety notes for the laser projector.
Do not look at the laser beam.
• Never point the laser beam towards
people or animals.
• Never use the laser beam on very
reflective materials. There is a risk
posed by the reflected light.
• Have repairs to the laser projector
carried out by specialists only.
• Do not introduce hard objects into the
laser optic (13).
• Clean the laser optic with a soft, dry
brush.
7 – Installation and setting
Electronic stroke rate control/stroke
rate pre-selection function
To saw according to the
material type, use the
adjustment wheel (2)
to set a suitable stroke rate 1–6
-1
(0–3000 min ) and control using the
On/Off switch (1). The adjustment wheel
also serves to implement stepless
adjustments of the stroke rate during
operation.
Pendulum
The adjustable pendulum
movement (P) of the saw blade (0
for hard materials, up to 3 for soft
0 I II
materials) improves the adjustment of the
machine to the material being processed.
And at the same time, it reduces wear on
the saw blade, improves the rejection of
shavings and considerably reduces the
formation of heat caused by friction.The
08.02.2010 13:35 Uhr
activation of the pendulum function may
also be carried out when the machine is
already running. Recommendations
regarding the machine settings can be
found on Figure 4.
Inserting the saw blade (Figure 2)
CAUTION! Disconnect the power
before each change of saw blade!
Turn and hold the ring of the saw
blade holder (A) in the (a) direction.
Insert a saw blade into the holder as
far as it will go, or remove an existing
one. Release the ring. Slot the saw
blade into the groove and push it in as
far as it will go, ensuring that the spine
fits well into the groove of the guide roll.
The ring returns to position (b) and locks
the saw blade in place.

Parallel stopper

EXACT
saw shoe and fixed using two screws
(Figure 1). The parallel stopper enables
parallel cuts along a stopper edge.
Dust removal
opening (7) on the jigsaw or to the
supplied adapter (2). The drawn down
cutting protection element (6) will
improve the efficiency of the dust
removal process.
Mitre/bevelled cuts
0 - 45° 0 - 45°
factory. To set it for mitre or bevelled
Seite 53
The supplied parallel stopper is
pushed through the
accommodation point on the
The extraction hose of the
household vacuum should
be fitted to the extraction
The saw shoe (10) is set to
the middle position (O°) when
the machine leaves the
53