INFOSEC UPS SYSTEM Zenergy Station 2000 Notice D'utilisation page 8

Step1:
Switch-off the station and disconnect it
from the mains power.
Remove the screws located on the
bottom of the Zenergy Station to open
the battery cover.
Step2:
After removing the battery cover, gently
extract battery from the case.
Step 3:
Disconnect the two wires linked to the
Zenergy Station and replace the battery
by the same type. (Red :+ / Black : -)
Dispose of the old battery properly at an
appropriate recycling facility.
9 . T R O U B L E S H O O T I N G
Should the Zenergy Station fail to function correctly we recommend you to perform the
following tests before calling the Hot Line.
Symptom
Orange led is lighting
and audible alarm is
heard intermittently.
Zenergy Station is
functioning but the
audible alarm is heard
continuously or twice a
second.
1 0 . I N S U R A N C E F O R C O N N E C T E D E Q U I P M E N T
The equipment connected to the Zenergy Station benefits from a free insurance up to
120000 €. To get further information and register, please visit the Infosec web site.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière – 44700 Orvault – FRANCE - www.infosec.fr
8
Hot Line : tel : + 33 (0)2 40 76 15 82 - fax : + 33 (0)2 40 94 29 51 - hotline@infosec.fr - 11 04 04 204 11
Possible cause
Zenergy Station is not
connected properly to
the mains power.
Overload of the
Zenergy Station.
Solution
Properly connect the
Zenergy Station according
to the installation section
of this user guide.
Check that the load
matches the Zenergy
Station capacity specified
in the technical
specifications of this user
guide.