Ecom Ident-Ex 01 Mode D'emploi page 7

FCC § 15.21 Information to user
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Canadian Digital Apparatus Compliance
This device complies with Industry Canada license-exempt RSS standards.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
CE COMPLIANCE STATEMENT HEAD MODULES
Users of this product are cautioned to use accessories and peripherals ap-
proved by ECOM Instruments GmbH. The use of accessories other than those
recommended, or changes to this product that are not approved by ECOM
Instruments GmbH, may void the compliance of this product and may result
in the loss of the user's authority to operate the equipment.

There are no user serviceable parts inside the SE955, SE965 or Ex25i.
Use of controls or adjustments, or performance of procedures other than
those specified herein, may result in hazardous laser light exposure of up to
≤1 mW at 630 to 670 nm. EN 60825-1:2007 | IEC 60825-1:2007
Radiation Exposure Statement
Warning: This equipment complies with International Commission on Non-
Ionizing Radiation Protection (ICNIRP), IEEE C95.1, Federal Communications
Commission Office of Engineering and Technology (OET) Bulletin 65, Canada
RSS-102, and European Committee for Electrotechnical Standardization
(CENELEC) limits for exposure to radio frequency (RF) radiation.
If a body worn accessory is not purchased from ECOM Instruments GmbH,
the accessory must contain no metal.
7