Ecom Ident-Ex 01 Mode D'emploi page 6

FCC COMPLIANCE STATEMENT HEAD MODULES
Laser Compliance and Precaution
The SN-SE955, SN-SE965 and Ex25i is registered with the CDRH as a Class
II Laser Product (21 CRF Subchapter J, Part 1040). This product has a maxi-
mum output of 1 mW at 630 to 670 nm.

There are no user serviceable parts inside the SE955, SE965 or Ex25i.
Use of controls or adjustments, or performance of procedures other than
those specified herein, may result in hazardous laser light exposure of up to
≤1mW at 630 to 670 nm. Complies with 21CFR1040.10 and 1040.11 except for
deviations pursuant to Laser Notice No. 50,0 dated July 26, 2001.
IEC 60825-1:2007
Use of controls, adjustments or performance of procedures other than those
specified herein may result in hazardous laser light exposure. Class 2 laser
scanners use a low power, visible light diode. As with many very bright light
source, such as the sun, the user should avoid staring directly into the light
beam. Momentary exposure to a Class 2 laser is not known to be harmful.
U.S.A. Digital Emissions Compliance
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interferen-
ce at his own expense.
FCC RF Exposure Statement
This device complies with part 15 of the FCC Rules and Industry Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference received, including interference that may
cause undesired operation.
6