Wolpertech 04011 Traduction Du Mode D'emploi D'origine page 12

compressor engine to clean out. After cleaning, follow the
lubrication instructions.
Troubleshooting
Problem Possible cause
No power Too small amount of
air (see Technical
specifications)
Impact Insufficient air pressure Check the air pressure
wrench not
working or
working
Air pressure set too
too slow
low
Impact wrench must be
lubricated with oil
Impact wrench must be
cleaned out
Air hose is leaking
Service
Any technical questions? Complaint? Do you need spare
parts or operation manual?
Go to our website www.guede.com and the section Service
will help you quickly and without bureaucracy. Please, help us
to help you. In order to identify your device in case of
complaint, please indicate serial number, order number and
year of manufacture. All information is available on the
product label. To have all information always at hand, put
them down.
Serial number:
Order number:
Year of manufacture:
Phone: +49 (0) 79 04 / 700-360
Fax: +49 (0) 79 04 / 700-51999
E-Mail: support@ts.guede.com
Important information for the customer
Please be sure to know that returning the product in or after
the warranty period must be made in the original packaging.
Problem solution
Bigger compressor
on the air inlet. It must
be 6 bar.
Increase the pressure
to 6 bar
See Lubrication
See Servicing
Tighten all the hose
screwing
12