Publicité
Les langues disponibles
Les langues disponibles
Use a tie strap to secure the cables as shown.
1. Solenoid connector
2. Tie strap
Position the EMM on the starter housing. Install
and tighten self-taping screws carefully.
IMPORTANT: Turn self-tapping screws counter
clock-wise to start the threads and clockwise to
tighten. Failure to follow this procedure can dam-
age the threads of the housing.
1
1. EMM
2. Self-tapping screws
Connect the cooling hose (P/N 353918) from the
EMM to the battery charge module as shown.
Secure with tie straps.
1
2
1. Cooling hose
2. Battery charge module
Connect the cooling hose (P/N 353917) from
battery charge module to the overboard indicator
fitting (exhaust grommet fitting). Secure with tie
straps. Attach touch troll connector and retainer
to straight hose.
1
007259
2
1. Battery charge module
2. Fitting, exhaust grommet
3. Touch troll connector
WARNING
Secure wiring to prevent contact with mov-
ing parts. Contact can cause outboard
damage or personal injury.
Reinstall spark plug leads.
Reinstall lower engine cover. Route battery
cables through the grommet on the port side of
2
the lower engine cover.
Secure MWS connectors to starboard cover with
tie straps. Seal tie strap holes with tape.
1
007241
1. Tie straps
007238
3
007239
007247
5 of 7
Publicité
