Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Refer to the appropriate service manual for
additional information.
Remove starboard lower engine cover.
WARNING
To prevent accidental starting during
installation, twist and remove all spark
plug leads.
Remove the touch troll connector and retainer
from the cooling hose.
1
1. Touch troll connector and retainer
Remove cooling hose from the Electronic
Management Module (EMM) and the overboard
indicator. Remove tie straps and discard cooling
hose.
1
2
1. Cooling hose
2. Overboard indicator
Remove the EMM mounting screws. Positon the
EMM to the side.
Install the isolators and flanged spacers on the
battery charge module as shown.
1
007221
1.
Isolator
2. Flanged spacer
Cut the existing tie strap holding the engine
harness and insert a new tie strap as shown.
Install the battery charge module on the
crankcase assembly with 6 x 30 mm screws and
the large 6 mm washers. Tighten screws to a
torque of 31 to 48 in. lbs. (3.5 to 5.5 N·m).
Tighten tie strap to secure both the engine
harness and the battery charge harness.
1
007222
1. Engine harness
2. Battery charge module
007223
1
2
007252
2
007231
3 of 7
Publicité
