Stagnoli ULIXES Instructions page 14

Fixing the brackets to the post and gate
After having verified the optimum conditions for placing the plates and their alignment, fix them to the
post and gate permanently, either welding them or utilising expansion bolts (if the post is made of brick),
observing the value specified in Fig. 2.
Fixing the gear motor
Check before installation of the engine that the worm is well greased, the same operation carried out
periodically in order to ensure a correct handling of the automation during its operation.
Lock the gear motor at the back with the M8 hex head screw with nut and washer (Fig.3).
Fit the nut screw on the front bracket pin and tighten the traverse screw to lock it in the working position
(Fig. 4).
Fig.3
Istruzioni , Instructions, Betriebsanleitung, , Instrucciones
Bottom edge of the
bracket fixed to the post
Bottom edge of the
bracket fixed to the gate
Fig.2
GREASE
Fig.4
14