Inventory Of Contents; Features; Set Up Guide; Battery Installation - Aercus WS1173 Guide D'utilisation

1. Inventory of contents

1)
Base station
2) One WH2 remote sensor with mounting bracket
3) Instruction manual

2. Features


Wireless outdoor and indoor humidity (%RH)

Wireless outdoor and indoor temperature (°F or °C)

Records min and max humidity

Records min and max temperature

Barometric pressure 24-hour history graph (inHg or hPa)

Weather forecast tendency arrows

Forecast icons based on changing barometric pressure

12 or 24 hour time display

Perpetual calendar

Time alarm with snooze

Can receive transmissions from one sensor

LED backlight

Wall hanging or free standing

Synchronised instant reception

3. Set up Guide

3.1 Battery installation

Note: To avoid operating problems, please take note of the battery polarity when inserting the
batteries (permanent damage can be caused by inserting the batteries in the wrong direction). Use
good quality Alkaline batteries and avoid rechargeable batteries.
1) Insert two AAA batteries into the remote sensor.
2) Insert three AA batteries into the weather station.
3) Wait 3 minutes or until the outdoor temperature is displayed in the weather station. Do not press any
keys before the outdoor sensor data has been received.
4) Mount the units, ensuring that the receiver can still pick up the signal from the transmitter. To measure
outdoor temperature, place the transmitter outdoors. It will transmit the temperature from its location.
Every time the remote sensor is powered up (for example after a change of batteries) a random security
code is transmitted and this code must be synchronised with the base station to receive weather data. Thus
if the batteries have been changed on the transmitter, then the receiver must be powered up again
to re-learn the transmitter code.
Note: DO NOT PRESS ANY KEY during the first 10 minutes of the learning period. After the outdoor
weather data is displayed you can place your remote sensor outdoors and set your time. If there is no
temperature reading in the indoor station make sure the units are within range of each other or repeat the
battery installation procedure. If a key is pressed before the weather station receives the temperature signal
you will need to follow the battery installation procedure again. Please wait 1 minute before re-inserting
the batteries again to perform a proper reset for both the transmitter and receiver.
Note: When batteries require replacement in the base station the low battery indicator will light up on the
LCD.
Please participate in the preservation of the environment by properly disposing of all used batteries at designated
disposal points. Never dispose of batteries in a fire as this may cause an explosion/risk of fire or leakage of
dangerous chemicals and fumes.
- 3 -