Sleep Mode; Adjusting The Fan Speed - Airwell RC08C Guide D'utilisation

OPERATIION
DEHUMIDIFYING (DRY)
1. Press the ON/OFF ( ) button and switch the air condioner ON.
2. Set the MODE selector switch to "DRY"
3. Press the + or - buttons to set the desired temperature (Adjustable temperature
range is 17℃ and 30℃(62-88F)).
Note: You cannot switch the fan speed in AUTO mode, it has been automatically
controlled.
THE DISPLAY SHOWS THE
SELECTED TEMPERATURE.
NOTE
Use DRY operation when you want to reduce the humidity in the room.
Once the room temperature reaches the set level, the unit repeats the cycle of turning on
and off automatically
During DRY operation, the fan speed is automatically set to low or stops to prevent overcooling .
FAN ONLY
If you want to make air circulate without any temperature control, follow these steps:
1. Press the ON/OFF ( ) button and switch the air conditioner ON.
2. Set the MODE selector switch to "FAN"

ADJUSTING THE FAN SPEED

AUTOMATIC
Simply set the FAN SPEED selector to the
automatically controls the fan speed when the AUTO mode is selected. When the air
conditioner starts operating, the difference between the room temperature and the set
temperature is detected by the microcomputer which then automatically switches the
fan speed to the most suitable level.
7
.
.
position . A microcomputer
MANUAL
If you want to manually adjust speed just set the FAN SPEED selector as desired.
Each time the button is short pressed, the fan speed is changed in sequence:
4 fan speed setting:
( (Low) (High) (
(Medium) (
SILENT MODE
To select the silent mode, hold down the Fan Speed button for at least 2 seconds and
then you can switch to the silent mode.

SLEEP MODE

The SLEEP mode enables you to save energy.
1. Set the MODE selector to cool, or heat.
2. Short press the SLEEP/ECO button
3. The mark appears on the display. Short press the SLEEP/ECO button again
to release the SLEEP function.
What does the SLEEP mode mean ?
In this mode, the air conditioner will cool or heat the room to the set
temperature. After about 1 hour, the air conditioner will automatically reset the
set temperature as follows (also refer to graphs).
OPERATING MODE
Heating
Cooling
8
OPERATIION
( Auto) ( Auto)
SET TEMPERATURE CHANGE
Lowered by 1 ° C
Raised by 1 ° C