Automatic Operation - Airwell RC08C Guide D'utilisation

OPERATIION
COOLING
Verify that the unit is connected to the main
power and the STANDBY lamp is lighted up.
1. Press the ON/OFF ( ) button and switch the
airconditioner ON.
2. Set the MODE selector to COOL .
3. Press the - or +. buttons to set the desired
temperature The temperature range is between
17℃ and 30℃(62-88 F).
THE DISPLAY SHOWS THE
SELECTED TEMPERATURE..
4. Press the FAN SPEED button to select the fan
speed.
HEATING
1. Press the ON/OFF ( ) button and switch the air condioner ON.
2. Set the MODE selector to HEAT .
3. Press the + or -. buttons to set the desired temperature, the temperature range is
between 17℃ and 30℃( 62-88F).
4. Press the FAN SPEED button to select the fan speed.
THE DISPLAY SHOWS THE
SELECTED TEMPERATURE..
5
MODE CLR
TIMER SET
SLEEP
TURBO
ECO
ION EYE
I FEEL
LIGHT
CLEAN
NOTE
For several minutes after the start of heating operation, the indoor fan will not run until
the indoor heat exchanger coil has warmed up sufficiently. This is because the COLD
DRAFT PREVENTION SYSTEM is operating.
DEFROSTING OF HEAT EXCHANGE / OUT DOOR UNIT "STANDBY"
When the outdoor temperature is low, frost or ice may appear on the heat
exchanger coil, reducing the heating performance.
microcomputer defrosting system operates. At the same time, the fan in the
indoor unit stops until defrosting is completed. Heating operation restarts after
several minutes. ( This interval will vary slightly depending on the room and
outdoor temperature).
HEATING PERFORMANCE
A heat pump air conditioner heats a room by taking heat from outside air. The
heating efficiency will reduce when the outdoor temperature is very low.

AUTOMATIC OPERATION

1. Press the ON/OFF ( ) button and switch the air conditioner ON.
2. Set the MODE selector to AUTO .
When this setting is selected, the air conditioner calculates the difference between the
thermostat setting and the room temperature and automatically switches to the COOL,
DRY or HEAT mode as appropriate.
3. Press the + or -. buttons to set the desired temperature, the temperature range is
between 17℃ and 30℃( 62-88F).
Note: You cannot switch the fan speed in AUTO mode, it has been automatically
controlled.
6
OPERATIION
When this happens, a