Dremel US40 Consignes De Fonctionnement/Sécurité page 12

DM 2610031544 01-14_US40 1/17/14 11:25 AM Page 12
Thank you for purchasing the Dremel US40.
This tool was designed to tackle a wide variety
of projects in and around the home. The
Dremel US40 completes tasks quicker and
more efficiently than a series of other tools that
would be needed to complete a job or project.
This tool is also compact, ergonomic, and cuts
virtually all common materials.
After using your new Dremel US40 you'll find
that it is the right size tool to get projects done
at just a fraction of the size of a traditional
circular saw. With a full line of accessories the
tool cuts through virtually any common material
in the home- wood, plastic, metal, drywall and
tile. The tool also features two cutting wheel
positions, one position using a standard flat
Hold the tool with both hands
W RNING
while starting the tool, since
torque from the motor can cause the tool to twist.
Start the tool before applying to work and let
the tool come to full speed before contacting
the workpiece. Lift the tool from the work
before releasing the switch. DO NOT turn the
switch "ON" and "OFF" while the tool is under
load; this will greatly decrease the switch life.
PADDLE SWITCH WITH
"LOCK-OFF" FEATURE
The Paddle switch enables the operator to
control the switch functions of "Lock-OFF",
and "ON/OFF".
TO UNLOCK SWITCH AND TURN TOOL
"ON": Push "Lock-OFF" switch release lever
forward to unlock paddle switch, then squeeze
paddle switch (Fig. 8).
TO SWITCH TOOL "OFF": Release pressure
on paddle lever. The switch is spring loaded
and will return to "OFF" position automatically
(Fig. 8).
"LOCK-ON" BUTTON
The "Lock-ON" feature, incorporated into the
paddle switch, is a convenience for long
operations.
TO LOCK SWITCH "ON": After paddle switch
has been activated push "Lock-ON" button at
Introduction
wheel for all your typical straight cuts and a
second position for making flush cuts along
flooring or against a wall.
In addition to versatility, the Dremel US40
provides excellent line of sight for confident,
precise cuts so you will get accurate cuts the
first attempt and avoid wasting time or material.
Visit www.dremel.com to learn more about
what you can do with your new Dremel tool.
This Dremel US40 tool is intended for straight
cuts in wood, plastic, metal, drywall, fiberboard,
and tile using the applicable accessories
recommended by Dremel.
Operating Instructions
FIG. 8
rear of tool completely in and release paddle
switch (Fig. 7).
TO SWITCH TOOL "OFF": Squeeze and
release paddle switch (Fig. 8).
In order to try to avoid recoil (a situation where
the wheel wants to skip out of the material) it
is recommended to make cuts in the same
direction as the rotation of the wheel.
this manual called "Kickback and Related
Warnings"
-12-
INTENDED USE
"Lock-OFF"
Paddle
Switch Release
Switch
It is important to read and
W RNING
understand the section in
"Lock-ON"
Button
Lever