BGS technic 407 Mode D'emploi page 4

OPERATE
1. Install the equipment into the spindle recess of the drill/driver as a
bit or into the chuck of the driving tool. You may need to adjust the
torque for different size thread nuts .
2. While holding the equipment fast, start the driver anticlockwise.
Keep holding the equipment while the drill slowly turns until you
hear it click as the sight window is closed .
3. Choice the required pulling bolt and nosepiece for the nut size.
4. Mount the threaded mandrel and the nosepiece to the rivet nut
attachment device.
5. Mount the rivet nut onto the threaded mandrel .
6. Set the drilling machine to the clockwise direction, make sure the
speed should not be too high.
7. For riveting, the device must be firmly pressed onto the workpiece.
When riveting, hold the drill and the rivet nut attachment with both
hands. Start the drilling machine to clockwise direction until the
riveting process is completed .
8. After the riveting process is finished, set the drilling machine to
slowly counterclockwise direction and remove the tie bolt from the
rivet nut .
Maintenance and Cleaning
Before cleaning or maintaining, first disconnect the plug from power mains and make sure the driving tool
cannot get started inadvertently.
Do not clean the rivet nut riveter with sharp detergents or aggressive chemicals.
Disposal
Tool, accessories, and packaging should be sorted for environment-friendly recycling.
If your tool can no longer be used, then please keep in mind that many of its components consist of
valuable materials, which can be recycled. Please do not dispose it in the rubbish bin, but check with your
local council for recycling facilities in your area.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed