Getting Started - INTERTECHNO IT-K2300 Mode D'emploi

GB
300
angat- The IT-K2300 wireless adapter plug can be used to wirelessly switching on/off lamps
and electrical appliances up to a switching capacity of 2300 watts!
All intertechno transmitters can be used for activation.
Remote motion sensors, timers, wall transmitters, dimmer switches,
mini transmitters and much more are available.
The remote adapters ITLR-3500 and ITLR-3500T can also be switched on and off at the
learn button, without a remote control being necessary.

GETTING STARTED

Please also observe the operating instructions for your transmitter.
Encoding
Have the transmitter ready and connect the adapter
to the socket. Fig. 1
1.) Press the Learn button (L) on the receiver (approx. 2 sec.) Fig. 2
until the green LED flashes slowly.
The remote adapter is now ready to learn for about 30 seconds.
2.) Press the required button on the transmitter ("ON").
The remote adapter switches on to indicate the new code has been accepted.
nnitel- A maximum of 8 codes (transmitters) can be configured in total. This also makes
planned group activation very easy.
ko Several remote receivers can be switched on and off individually or together.
Codes remain stored even after the device has been unplugged or if there is a
aan. power failure.
How to erase codes
mitaan To erase an individual code on the receiver, proceed as in 1.) and 2.).
In this case, however, press the "OFF" button instead of the "ON" button on the
yesti. transmitter.
To erase all stored codes (reset), press and hold the learn button (L) until the LED
ään
flashes quickly (approx. 6 sec).
Then, press the learn button (L) again briefly.
This erases all codes.
The transmitters are not required for this procedure.
Encoding with new transmitters can now commence.
To view the declaration of conformity, please visit www.intertechno.at/CE
Operating instructions
DONE!
IT-K2300