Cd Programmed Play; Aux In Operation - LEXIBOOK RCD102 Série Mode D'emploi

Use the program function to preselect the order in which a sequence of tracks
will be played. Up to 20 tracks can be programmed.
1. Slide the FUNCTION selector to the CD position.
2. Press PROG., "01" will blink on the display.
3. Use SKIP FORWARDS or SKIP BACKWARDS to select the first track to
include in the programmed sequence.
4. Press PROG. to confirm and store the track.
5. Repeat steps 3 and 4 to program the other desired tracks.
6. Press PLAY to begin playback. The tracks will be played in the
programmed order. The PLAY/PAUSE/PROG indicator flashes when the
program function is in used.
Note:
• To cancel the program function, press the STOP button until the PLAY/
PAUSE/PROG indicator goes off.
• During program setting, press STOP or open the CD door.
You can play music through the speakers of this Radio CD Player by
connecting its AUX IN jack to your MP3 or other digital audio player.
1. Plug one end of an audio cable (not included) into the AUX IN jack
located at the back of the unit, and the other end of the cable to the line
out jack of the device you want to connect.
2. Slide the FUNCTION selector to the CD or the RADIO position.
3. Adjust the VOLUME control to your desired listening level.
4. Use the function keys of your audio device to pause and resume the
playback, adjust the volume and select the next or the previous track.
To prevent fire or shock hazard, disconnect your unit from the AC power
source when cleaning. The finish on your unit may be cleaned with a dust
cloth and cared for as other furniture. Use a soft, clean cloth moistened with
plain, lukewarm water to clean the exterior of the unit. Use caution when
cleaning and wiping the plastic parts. Mild soap and a damp cloth may be
used on the front panel.
Power supply: 230V AC ~ 50 Hz 10W or 6 x C/LR14 size batteries (9V
FM: 87.5 - 108 MHz
AM: 520 - 1620 KHz

CD PROGRAMMED PLAY

AUX IN OPERATION

MAINTENANCE
17 17
)