Stid SPECTRE Notice D'installation page 6

SPECTRE Access UHF
Read only
Installation procedure
ANT-UHF2-A
for SMA/SLA-R4x
Frequency Band 865 - 868 MHz
Antenna gain 8.30 dBi
Polarization Circular
Axial ratio 0.66
Beamwidth (-3 dB) 70°
Impedance 50 ohms
Cable TNC RP male
Protection Level IP66
Mount with 75 x 75 mm / 0.79 x 0.79 in Standard VESA
mounting bracket (M4x12 stainless steel screws provided
with mounting kit)
Horizontal polarization F = 867 MHz
STid declares that the SMA-R5x/R4x-A reader is compliant to the fundamental requirements of Directive RED 2014/53/EU and Directive RoHs 2011/65/EU and Commission Delegated
Directive 2015/863/EU. A copy of our declaration is available upon request send to qualite@stid.com.
This device complies with Part 15 of the FCC rules and with Innovation, Science and Economic Development Canada's license-exempt RSS(s). Operation is subject to the following two
conditions:
1) This device must not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and can emit radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for assistance.
This equipment complies with FCC's radiation exposure limits set forth for an uncontrolled environment under the following conditions:
- This equipment should be installed and operated such that a minimum separation distance of 25 cm / 7.8 in is maintained between the radiator (antenna) and the
user's/nearby person's body at all times.
- The transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
-
In response to the regulation, STid finances the Récylum recycling program dedicated to DEEE Pro. Electrical lighting equipment, control and
monitoring devices, and used medical devices are recycled free of charge.
More information at www.recylum.com.
© STid 2018 - 20 PA des Pradeaux FR13850 Gréasque - NI1127X02 - Page 5 sur 15 - Ed. 30/01/2019
UHF SPECTRE Access
Lecture seule
Notice d'installation
Antenna Specifications - ANT-UHF-V2
ANT-UHF2-B
for SMA/SLA-R5x
902 - 928 MHz
9.38 dBi
Circular
1.16
60°
50 ohms
TNC RP male
Level IP66
Antenna Mounting
Two mounting possibilities:
Adjustable wall-mounted kit
(refer to Installation Procedures
for KFX-UHF-08)
Wall
Azimuth pattern
Horizontal polarization F = 915 MHz
Declaration of Compliance
"DEEE Pro" Member
Acces UHF SPECTRE
Solo lectura
Manual de instalación
45.1 / 1.78
in
Adjustable ole-mounted kit
(refer to Installation Procedures
for KFX-UHF-09)
Vertical polarization F = 867 MHz
348.7 / 13.73
Pole
Vertical polarization F = 915 MHz