Important; Automatic Switch-Off - Seecode 20249 Mode D'emploi

IMPORTANT:

If the heat indicators light up or remain on, unplug the power cord from the wall socket immediately.
Preheat:
Press 1 X for low heat
Press 2 X for medium heat
Press 3 X for lots of heat
Press again for the off function
Press 1 X for slightly pulsating
Press 2 X for slightly permanent
Press 3 X for medium pulsing
Press 4 X for medium permanent
Press 5 X for strong pulsing
Press 6 X for strong permanent
Press again for the off function
WASHING INSTRUCTIONS:
ALWAYS DISCONNECT THE THERMAL WAISTCOAT FROM THE MAINS BY PULLING THE PLUG!
NOTE: ONLY THE COVER IS WASHABLE! DO NOT WASH THE HEATING PAD!
DO NOT DRY CLEAN! DO NOT USE BLEACH! DO NOT WRING OUT TO DRY.
1. open the zip on the side and loosen the inner straps of the heating pad up to the cover. (See fig. 7). Then
carefully remove the cover.
2. machine wash the cover in warm water on the delicate wash cycle and tumble dry on medium heat, then
remove directly from the tumble dryer.
3. wash the cover by hand in warm soapy water. Simply hang it up to dry.
4. after drying, put the heating pad back into the cover and fasten it again.
5. close the straps with a zip fastener afterwards.
Wait a few minutes for the heat waistcoat to preheat. IMPORTANT: If a red „HIGH" lamp flashes, it means
that an error has occurred. Immediately unplug the appliance and check the condition of the cable and the
operation of the mains socket. If the flashing stops, stop using the waistcoat and contact customer service.
To add heat, turn on the switch on the back of the controller, then press the heat activation button and
select the desired temperature: high or low.
To enable the massage function, turn on the switch on the back of the controller, then press the massage
enable key and select
Your desired speed:

AUTOMATIC SWITCH-OFF

The auto-off switch is in the control unit on the thermal waistcoat.
The Auto-Off function allows to save energy by automatically switching off after 2 hours of continuous use.
The massage function switches off automatically after 15 minutes of use.
IMPORTANT: The auto-off timer is reset after a power failure.