Volume Adjustment; Menu Options - Ecco EC2027-WC Instructions D'installation

VOLUME ADJUSTMENT

During single image modes, the volume can be adjusted using the + and - buttons on the monitor or the < and > buttons on the remote.
During split/quad image modes, the audio from one camera is selected through the split audio menu option, see below for details. Return to any single image mode to
adjust the volume.
SELECTING SPLIT CAMERA VIEW
Press the S button on the monitor until split view CAM1 and CAM2 appears on the screen. Press + or - on the monitor (or < or > on the remote control) to cycle through
all the split camera views.
SPLIT/QUAD IMAGE OVERRIDE SELECTION
To select the yellow trigger override, press the S button until split view CAM1 and CAM2 is on the screen. Apply and hold power to yellow trigger wire and press the +
or - button on the monitor (< or > on the remote) to cycle through all split camera views, including quad view. When desired split or quad override view is found, remove
yellow trigger wire from power. Wait for camera view to reset. Press S to change to camera view and return to normal viewing mode. Touch the yellow trigger wire to
power wire to test if the trigger override is working properly. This view will override all standard views when power is applied to yellow.

MENU OPTIONS

Press M (or MENU on the remote) to display the following options and settings:
1. PICTURE 5. AUTOSCAN
2. SPLIT-AUDIO 6. SYSTEM
3. MIR-FLIP 7. PLAY
4. RECORD 8. PAIRING
MENU OPTION: PICTURE
IMAGE MODE OPTIONS
Using the monitor:
1. Press S to enter the single image mode to be adjusted.
2. Press M to enter the Menu
3. Use the + or - to highlight the PICTURE Option
4. Press the down arrow to enter the PICTURE Option
5. Use the + or - to highlight the desired adjustment
6. Press the down arrow to enter the adjustment option
7. Use the + or - to change the settings
8. Press the down arrow to exit the adjustment option
9. Press M twice to return to the main screen
Using the remote:
1. Press SEL to enter the single image mode to be adjusted
2. Press MENU to enter the Menu
3. Use the < or > to highlight the PICTURE Option
4. Press OK to enter the PICTURE Option
5. Use the < or > to highlight the desired adjustment
6. Press OK to enter the adjustment option
7. Use the < or > to change the settings
8. Press OK to exit the adjustment option
9. Press MENU twice to return to the main screen
Page 6 of 11