Installation And Connection - aquanique FP Série Notice D'emploi

Installation and connection

W A R N I N G
Electrical current may cause death or severe injuries.
• Do not use this product in swimming pools, jacuzzis, whirlpools, etc.
How to proceed:
 A
• Adjust the flow rate of the pump at the flow regulator on the unit.
– To increase the flow rate: Turn/push the flow regulator in the + direction.
– To decrease the flow rate: Turn/push the flow regulator in the - direction.
• Install the adapter on the outlet
• Fasten the hose on the adapter.
 C
• Install the pump fully submerged.
– Ensure that the maximum permissible submersion depth of 0.9 m is not ex-
ceeded
– Route the power cable so that it forms a loop below the power socket.
Commissioning/start-up
N O T E
Prevent the pump from running dry. Otherwise the pump will be de-
stroyed.
• Only operate the pump when it is immersed.
• Switching on: Insert the power plug into the socket.
– The unit switches on immediately.
• Switching off: Disconnect the power plug.
- EN -
19