IMPORTANT SAFETY INSTRUCTIONS WARNING FOR YOUR PROTECTION READ THE FOLLOWING: READ THESE INSTRUCTIONS. KEEP THESE INSTRUCTIONS. HEED ALL WARNINGS. The symbols shown above are internationally accepted symbols that warn FOLLOW ALL INSTRUCTIONS. of potential hazards with electrical products. The lightning flash with DO NOT USE THIS APPARATUS NEAR WATER.
WARNING: IF THE GROUND IS DEFEATED, CERTAIN FAULT CONDITIONS IN THE UNIT OR IN THE SYS- TEM TO WHICH IT IS CONNECTED CAN RESULT IN FULL LINE VOLTAGE BETWEEN CHASSIS AND EARTH Harman Music Group GROUND. SEVERE INJURY OR DEATH CAN THEN RESULT IF THE CHASSIS AND EARTH GROUND ARE TOUCHED SIMULTANEOUSLY.
CONSIGNES DE SÉCURITÉ IMPORTANTES AVERTISSEMENT POUR VOTRE SÉCURITÉ LIRE ATTENTIVEMENT : LIRE CES CONSIGNES. CONSERVER CES CONSIGNES. RESPECTER TOUS LES AVERTISSEMENTS. SUIVRE TOUTES LES CONSIGNES. Les symboles illustrés ci-dessus sont des symboles acceptés NE PAS UTILISER CET APPAREIL PRÈS DE L’EAU. internationalement qui avertissent des dangers potentiels relatifs à...
DE L'APPAREIL OU DU SYSTÈME AUQUEL IL EST RELIÉ, POUVANT SE TRADUIRE PAR UNE TENSION COM- POSÉE ENTRE LA MASSE ET LA PRISE DE TERRE. CELA PEUT PROVOQUER DES BLESSURES SÉRIEUSES OU Harman Music Group FATALES SI LA MASSE ET LA PRISE DE TERRE SONT TOUCHÉES EN MÊME TEMPS.
Front panel BLU-BOB1 BLU-BOB2 Signal The Signal LED illuminates for each channel where a signal is present. Power The Power LED illuminates when the BLU-BOB device is powered on.
United States. If the design requires pull-down and you have a pre v1.05 BLU-BOB, please contact Customer Services at bss.support@harman.com for guidance. BLU-BOBs with a sticker on the rear panel showing V1.05 or above are compatible with pull-down rates.
Page 8
Installing BLU-BOB into a Rack The BLU-BOB2 and the BLU-BOB1 each offer 8 channels of line-level analog output expansion from the Soundweb London digital audio bus (informally known as “BLU link”). The BLU-BOB2 can be mounted directly into a single 1U rack space. The BLU- BOB1 is a half-width version, and it requires the Rack-Mount Kit to mount it into a single 1U rack space (see “Using the Rack-Mount Kit”...
Page 9
Using the Rack-Mount Kit (shipped separately) The BSS Audio 1U Rack-Mount Kit (SKU: RACK MOUNT KIT) allows up to two half- rack Soundweb London devices—BLU-BIB and BLU-BOB1—to be mounted on a shelf occupying a single rack space. The 1U Rack-Mount Kit can accommodate one BLU-BIB device, one BLU-BOB1 device, two BLU-BIB devices, two BLU-BOB1 devices, or one of each device.
Page 10
Assigning Channels with the DIP Switch CHANNELS DIP SWITCH SETTINGS CHANNELS DIP SWITCH SETTINGS CHANNELS DIP SWITCH SETTINGS CHANNELS DIP SWITCH SETTINGS 1 to 8 65 to 72 129 to 136 193 to 200 9 to 16 73 to 80 137 to 144 201 to 208 17 to 24...
Technical Specifications: Front Panel LED Indicators: Signal present per output, and Power Analog Outputs: 8 electronically balanced on Phoenix/Combicon removable screw connectors Maximum Output Level: +19dBu Frequency Response: 20Hz-20KHz (+0.5dB/-1dB) THD: <0.01% 20Hz to 20KHz, +10dBu output Dynamic Range: 110dB typical, 20Hz-20KHz unweighted Crosstalk: <-105dB 20Hz-20KHz D/A Latency:...