Fein KBM 32 Q Notice D'utilisation page 14

3 41 01 011 06 3.book Seite 14 Montag, 16. Februar 2015 12:50 12
EN
Coolant container (12h),
Pump holder (12i),
Coolant tube (12j),
Power tool carry case, plastic (12k).
Only part of the accessories described or shown
in this instruction manual will be included with
your power tool.
Intended use of the power tool.
This power tool is intended for commercial use
as a core drill for drilling materials with a mag-
netizable surface using core drill bits or twist
drill bits, and for reaming, countersinking and
tapping in a weather-protected environment
using the application tools and accessories rec-
ommended by FEIN.
The power tool can be used horizontally, verti-
cally or overhead.
The appliance is not to be used by persons
(including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction.
Children being supervised not to play with the
appliance.
Instructions for putting into
operation.
Please make sure that the contacting surface for
the magnetic foot is level, clean and rust-free.
Remove any varnish or primer.
When working on materials that are not mag-
netizable, suitable fixation devices, obtainable as
accessories from FEIN, e. g. suction plate, vac-
uum plate or pipe-drilling device must be used.
When work on steel materials with a material
thickness of less than 12 mm, the workpiece must
be reinforced with an additional steel plate in order
to guarantee the magnetic holding power.
Mounting the guard protecting against
chippings and accidental contact (Figure 7).
The guard protecting against chippings and
accidental contact must always be mounted
during operation.
14
Mount the guard protecting against chip-
pings and accidental contact (7).
To remove any accumulated chippings,
open the guard protecting against chip-
pings and accidental contact (7).
Before commencing operation, fasten
the guard protecting against chippings and
accidental contact (7) with the hook (7a).
Mounting the coolant container.
Place the filled coolant container (12h)
into the holder provided on the motor
housing.
Only use cooling lubricant that is capable of
being pumped.
Connect the coolant tube (12j).
Operating instructions.
Adjustments.
Set the stroke range (Figure 1).
For changing the tool easily and fast, the setting
of the stroke range is infinitely variable.
Loosen the lever (1) and set to the
required stroke range.
Before commencing operation, tighten
the lever (1) firmly again.
Changing the tool.
Core bit (Figure 10).
Push the centering pin (12d) through the
core bit.
Turn the Quick IN clamping collar (10)
of the tool holder anti-clockwise and insert
the core bit with the centering pin.
Let go of the Quick IN clamping col-
lar (10) and turn the core bit in the tool
holder until the catch notches.
Twist drill and core drill bits with M 18x6/P 1.5
(Figure 11).
Screw the adapter (11) onto the geared
drill chuck.
Turn the Quick IN clamping collar (10)
of the tool holder anti-clockwise and insert
the adapter (11) in the same way as the
core bit.
KBM 32 Q