Parts And Features; Battery Back-Up; Radio Operation - Hamilton Beach Commercial HCR329 Mode D'emploi

840120000 Ev02.qxd 11/20/03 1:26 PM Page 4

Parts and Features

1. On/Off/Auto
2. Alarm Set/Off
3. Sleep
4. Time Set
5. Hour
6. Minute
7. Volume Control/Buzzer
8. Band Selector
9. Tuning Control
10. Snooze Button

Battery Back-Up

This clock radio features an optional battery back-up to retain
the correct time setting in the event of a power failure or when
disconnected temporarily from an outlet. The clock display will not be
lit and the radio/alarm functions will not operate while the power is
interrupted however, the time and alarm settings will be maintained
in memory. Once power is restored, the display will show the correct
time and the radio and alarm functions will operate normally.
To prevent leakage and possible damage to the unit, the battery
should be replaced when it no longer retains the time during a power
failure (the clock display will flash to indicate that the time needs to
be reset).
1. Remove the battery cover on the bottom of the clock radio.
2. Connect a fresh alkaline 9-volt (006P) battery (not included) to the
terminals inside the battery compartment.
3. Replace the battery cover and set the time as described in "How
to Set the Clock."
4
Operation
How to Set the Clock
Until the clock has been set, the digital display will flash.
1. Plug the cord into a polarized 120V outlet.
2. While pressing the TIME SET button, press the HOUR button until
the correct hour is shown in the display. Press the MINUTE button
until the correct minute is shown.
NOTE: Pressing and holding the HOUR and MINUTE buttons will
advance the hour and minute automatically. Press and release the
buttons to advance one hour or minute at a time.
3. Once the correct time is set, release the TIME SET button.

Radio Operation

1. Slide the ON/OFF/AUTO switch to the ON position.
2. Slide the band switch to AM or FM.
3. Turn the volume control to the desired volume.
4. Turn the tuning control to select the desired station.
Antenna: For AM reception, this unit features an integrated ferrite
core antenna. For FM reception, an antenna is built in to the power
cord. For best reception, make sure that the power cord is extended
to its full length.
Wake to Radio
Once the desired station and volume level is set:
1. Slide the ON/OFF/AUTO switch to the AUTO position.
2. While pressing the ALARM SET button, press the HOUR and
MINUTE buttons until the desired wake time is shown in the
display. Release the ALARM SET button. The wake time is now
set in memory.
3. To check the wake time, simple press the ALARM SET button and
the set wake time will be displayed.
4. The radio will turn on at the set wake time. To turn the radio off,
press the ALARM OFF button.
5