Safety Information - Dometic GROUP WAECO PerfectView MC402 Instructions De Montage

Safety information

✓ This symbol describes the result of an action.
Fig. 1 5, page 3: This refers to an element in an illustration. In this case,
item 5 in figure 1 on page 3.
2 Safety information
The manufacturer accepts no liability for damage in the following cases:
 Faulty assembly or connection
 Damage to the product resulting from mechanical influences and excess
voltage
 Alterations to the product without express permission from the manu-
facturer
 Use for purposes other than those described in the operating manual
2.1 Safety when installing the device
Please observe the prescribed safety instructions and stipulations
from the vehicle manufacturer and service workshops.
WARNING!
!
Inadequate supply cable connections could result in short circuits,
which could have as a consequence that:
 Cable fires occur
 The airbag is triggered
 Electronic control devices are damaged
 Electric functions fail (indicators, brake light, horn, ignition,
lights)
NOTICE!
A
To prevent the risk of short circuits, always disconnect the negative
terminal of the vehicle's electrical system before working on it.
If the vehicle has an additional battery, its negative terminal should
also be disconnected.
Please observe the following instructions:
 When working on the following cables, only use insulated cable lugs,
plugs and flat push-on receptacles:
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return line from the battery, earth)
24
MC402
EN