Normal Operating Conditions - Elettrobar FAST 570.035 Manuel D'emploi

INSTRUCTION MANUAL FOR DISHWASHERS
 NEVER overturn the machine after it has been installed.
 If you notice any malfunction or fluid leak, immediately disconnect the power
supply and shut off the water supply.
 Do not install the dishwasher in the vicinity of heat sources over 50°C.
 NEVER leave the dishwasher exposed to the weather (rain, direct sunlight,
etc.)
 The dishwasher may not be installed outdoors without proper cover.
 Never start a wash programme without the overflow in the tub, as applicable.
 Never place magnetic objects in the vicinity of the machine.
 Do not use the top of the machine as a table or support.
 The installer is responsible for checking that the grounding system is fully
operational.
 At the end of testing, the installer must issue a written declaration stating that
the machine has been installed and tested in accordance with established
legislation and good practice.
 DO NOT change the position or tamper with the elements of the machine, as
this could compromise the machine safety.
 Noise pressure level according to EN ISO 4871
o LpA Max = 55db Kpa=2.5db for undercounter versions
o LpA Max = 65db Kpa=2.5db for hood versions
o LpA Max = 76db Kpa=1.5db for utensil washer versions
 Max inlet water temperature: 50°C
 Max inlet water pressure: 4bar (400kPa)
 Appliance designed for permanent connection to the water supply
 Do not clean the appliance with steam or water jets.
 Max loading height
o On the ground in the versions with overflow
o Maximum height 1 m in versions with discharge pump
Ambient temperature: 40°Cmax /4°Cmin (average 30°C)
Altitude
Relative humidity
: up to 2000 metres
: Max 30% at 40°C / max 90% at 20°C

1.1 Normal operating conditions

UK
Page 3 of 14