Handle Assembly - sunjoe 24V-CRLM15-CT Manuel D'utilisation

m
WARNING!
This charger does not automatically
turn off when the battery is fully charged. Please take care
not to leave the battery plugged into the charger. Switch
off or unplug the charger at the mains when charging is
complete.
5. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
6. When charging is complete, remove the battery from the
charger by pulling the push lock buttons and sliding the
battery backward to unlock it from the charger.
Assembly
m
WARNING!
Do not insert the battery and the safety key
until assembly is complete. Failure to comply could result in
accidental starting and serious personal injury.
m
WARNING!
Before performing any maintenance, make
sure the battery and the safety key are removed from the unit.
Failure to heed this warning could result in serious personal
injury.
m
WARNING!
The product must be fully assembled
before operation. Do not use a product that is only partially
assembled or assembled with damaged parts.
NOTE: Before using the reel mower, follow these instructions
to assemble the appliance.

Handle Assembly

1. Insert the ends of the lower handle frame into the sockets
on both side of the mower base. Lock with the lower
handle knobs provided (Fig. 4).
Fig. 4
Lower handle
frame
Socket
Lower
handle
knob
2. Fit the middle handle bars on both sides of the lower
handle frame, aligning the holes. Secure with two sets of
handle knobs and bolts (Fig. 5).
NOTE: Each middle handle bar has 2 holes on the top and
the bottom. Adjust the handle assembly to the optimal
position by aligning with the hole at the desired height.
Fig. 5
3. Fit the upper handle frame on both the middle handle
bars, as shown, aligning the holes. Secure with the
remaining two sets of handle knob and bolt (Fig. 6).
Fig. 6
Middle handle
bars
Lower handle
frame
4. Secure the cable with the two cable clips, as shown
(Fig. 7)
Fig. 7
Socket
Lower handle
Cable clips
knob
10
Middle
handle bars
Handle knob
+ bolt
Lower handle
frame
Upper handle
frame
Handle knob
+ bolt
Cable