Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. To start the cordless snow shovel, push and hold the
safety lock switch on the side of the handle grip with your
thumb and then squeeze the trigger switch with your
fingers. Once the machine powers on, you can release the
safety lock switch and proceed with operation (Fig. 10).
Fig. 10
Safety lock switch
Trigger switch
3. To stop the cordless snow shovel, release the trigger
switch.
Handle Adjustment
To adjust the angle of the auxiliary handle, follow the
instructions below:
1. Stop the machine and remove the battery. Wait until the
blade comes to a complete stop.
2. Loosen the auxiliary handle by turning the handle knob
counterclockwise. Rotate the auxiliary handle to a
comfortable position (Fig. 11).
Fig. 11
Auxiliary
handle
Handle knob
3. Fix the handle by tightening the handle knob. Insert the
battery and resume working.
To adjust the position of the auxiliary handle, follow the
instructions below:
1. Stop the machine and remove the battery. Wait until the
blade comes to a complete stop.
2. Loosen handle knob slightly and adjust auxiliary handle
as needed to desired position. Retighten handle knob
securely (Fig. 12).
Fig. 12
Auxiliary
handle
Loosen the
handle knob
3. Insert the battery and resume working.
NOTE: In order to prevent the auxiliary handle from moving
around or sliding on the pole, be sure to tighten securely.
Operating Tips
• Start the cordless snow shovel. Push the shovel forward
at a comfortable rate, yet slow enough to clear the path
completely. The clearing width of the snow shovel and the
depth of snowfall should dictate your forward speed.
• Direct the snow discharge to the right or to the left by
holding the cordless snow shovel at a slight angle.
• To remove snow most efficiently, throw the snow
downwind and slightly overlap each swath.
• If you need to clear snow from a crushed rock or gravel
surface, push down on the handle to keep the scraper
blade clear of any loose material that the rotor blades
could throw.
• This cordless snow shovel cuts a path 11 in. (28 cm) wide
and up to 7 in. (17.8 cm) deep in one pass.
• When clearing deeper drifts, hold the cordless snow
shovel by the upper and auxiliary handles and use a
swinging or sweeping motion. Remove up to 7 in. (17.8
cm) of snow with each pass and repeat as many times as
needed.
• Remove the battery after using the cordless snow shovel.
Hang the shovel so it will not be misplaced or damaged.
11
Publicité
Table des Matières
