Assembly Instructions; Tools Required - KaZAM WeeRide Instructions De Montage

MOUNTING THE CHILD CARRIER TO THE BIKE
WARNING! Failure to comply with these manufacturer's Instructions can lead
to serious injury of the passenger or rider.
TOOLS REQUIRED: Adjustable Wrench and Allen Wrench 5 mm.
STEP 1
Lay out parts and remove all packing materials.
STEP 2
The front and rear sections of the mounting bar are held together by a hex bolt
which screws into a bar support underneath the mounting bar (FIG. 4c). Using an
Allen wrench, remove the hex bolt and bar support. �et these two small parts
aside for now. Follow instructions for attaching the rear and front mounting bar
pieces in �TEP 3 below. The rear and front mounting bar pieces are then
reattached at the end of �TEP 3.
STEP 3
The mounting hardware has been pre-assembled to the support bar for your
convenience.
a. remove the back section of the rear bracket insert from the support bar
assembly.
b. Attach the support bar to the seat post between the frame and the bike seat.
Reinstall the rear bracket and bracket insert as shown in FIG. 4a.
c. Remove the front bracket and bracket insert from the support bar assembly.
d. DO NOT ATTACH THE SUPPORT BAR DIRECTLY TO THE HANDLEBAR STEM.
Attach the support bar to the head tube just BELOW the handlebar stem.
Reinstall the hardware and bracket/bracket insert as shown in FIG. 4b. When
securing hardware, apply normal hand tightening using the tools supplied/
required. Torque requirement 10 Nm.
NOTE: Make sure the resin bumper is in place between the support bar
and the head tube. This is to protect the finish of your bicycle.
e. You can now connect both rear and front pieces of the support bar back
together. Using the two small parts put aside in �TEP � above, fasten both bar
pieces with the hex bolt and bar support. Adjust bar assembly to fit snugly
across the bicycle. �ecurely fasten completed bar assembly with an Allen
wrench.
CAUTION: Check the security of all fasteners frequently.
manual WeeRide.indd 6

ASSEMBLY INSTRUCTIONS

6
11/01/11 03:14