Record Player Operation - Renkforce MT-35 Mode D'emploi

Stereo/mono reception
• Press the FM ST. button on the remote control to switch the reception of the radio to stereo or mono,
respectively.
• During stereo reception the ST symbol is shown in the display.
If the reception is bad it is recommended to change to mono operation as this suppresses the
interferences better.
If the reception quality is bad in stereo operation, unwind the FM wire aerial (25) completely or
align it differently.
In case of interferences during MW reception, the entire device may be slightly turned or posi-
tioned differently as MW reception is realised by an aerial integrated in the device.
h) Record player operation
Pull off the needle protection forwards from the pick-up before starting the record player.
Loosen the pick-up arm clamp before starting the record player and fasten the pick-up arm with
the pick-up arm clamp after use again.
• Press the PHONO button (5) to select record player operation.
• Set the correct playback speed depending on the record used with the 33/45/78 button (32).
• Set the AUTO STOP ON/OFF (31) as desired.
OFF: The turntable rotates as long as the record player mode is activated
ON: The turntable stops at the end of playback automatically
When using some records, the auto stop function may not work correctly as the area of the lead-
out groove does not comply with the standard.
• Put the record on the turntable. Use the single puck (29) when required.
• Lift the pick-up arm (33) with the pick-up arm lift (30) and swivel the pick-up arm over the record.
• Carefully lower the pick-up arm (33) with the pick-up arm lift (30) onto the record. Playback starts.
• The turntable drive stops automatically at the end of the record (condition: the AUTO STOP ON/OFF (31)
button is in the ON position).
• Lift the pick-up arm (33) with the pick-up arm lift (30) and swivel it pack to the pick-up arm support.
• If the AUTO STOP ON/OFF button (31) is in the OFF position or if you want the playback before the end
of the record, lift the pick-up arm (33) with the pick-up arm lift (30) and swivel it back to the pick-up arm
support.
42