Sirius Satellite Radio SL903-P Mode D'emploi page 15

All manuals and user guides at all-guides.com
The LED on the right side will start to flash
(every 5 seconds), the hood will work for 10
minutes at the selected speed and then it li-
ghts automatically off.
If the client increases or reduces the speed
while the timer is on, this is automatically
stopped.Standard configuration If two coo-
kerhoods-radiocontrol system are installed in
the same room or in the immediate vicinity,
each system may affect the operation of the
other, due to the fact that they have the same
code.
Therefore it will be necessary to change the
code of one of the radio controls.
Warning: The battery should be replaced
every yearto guarantee the optimal range of
the transmitter.
To replace the exhausted battery, take the
plastic lid off, remove the battery and replace
it with a new one, ob-serving the correct bat-
tery polarities.
Used batteries should be discarded in special
collection bins.Generating a new transmission
code The radiocontrol is supplied by the ma-
nufacturer with default codes stored. If you
want to create a new set of codes, proceed
as follows:press and hold the UP, STOP and
DOWN but-tons simultaneously for 2 secon-
ds. Afterthe LEDS light up, press the UP and
DOWN button swithin 5 seconds. The LEDS
will flash 3 times to indicate that the process
is completed.
WARNING: This procedure deletes all pre-
viously stored codes. Learning the new tran-
smission code After changing the transmis-
sion code on the radio control, the cooker
hood electronic control unit must be made to
set the new code as follows : press the main
Power Off button on the cookerhood and then
restore power to the electronic control unit.
The power off button can be seen after remo-
ving the grease filter.
Within the next 15 seconds, press the Light
button . This will ensure the control unit
is synchroni-zed with the new code.
15