Sirius Satellite Radio SL903-P Mode D'emploi page 14

INSTALLATION
SL907
Before carrying out installation, please remo-
ve the grease filter in order to avoid possible
damages to the appliance. Please follow the
following steps to remove the metal grease
filter: open the lighted panel first, by turning
it downwards ( fig.1) , then remove the grease
filter by operating on its handle and making
the filter rotate downwards, disengaging it
from its seat.
Make a hole on the surface of the following
dimensions:
270mm x 498mm for SL907 52cm model
270mmx675mm for SL907 70cm model
Insert the SL907 unit, making sure the push‐
button panel is placed on the right , looking at
the product from the front of the cook‐top.
Make the electric connection and connect
the air‐outlet flange to a suitable exhausting
pipe.
Fix the unit by using the four screws provided
and tighten them as shown in fig. 16.
Insert the grease filter again and close the
perimeter panel.
All manuals and user guides at all-guides.com
Herebelow the functions of the push but-
tons equipped in the products: SL903-P, SL
EM 903-P, SL907 (fig. 10):
A: Light switch on/off
B: Motor switch on/off (1st rate level)
C: 2nd rate level switch
D: 3rd rate level switch
E: 4th rate level switch
F: 10-minute timer.
Herebelow the functions of the push buttons
equipped in the products: SM903 (fig.11):
A: Light switch on/off
B: Motor switch on/off (1st rate level)
C: 2nd rate level switch
D: 3rd rate level switch
E: 10-minute timer
F: Warning gem
Remote control (dis. 15)
Technical data:
Alkaline battery powered: 12v mod. 23A
Operating frequency: 433.92 Mhz
Combinations: 4096
Max. consumption: 25mA
Operating temperature: -20° : +55°C
- To light the cooker hood on or to
light it off press the button:
- To increase the speed up to the
fourth one press the button:
- To reduce the speed up to the
second one press the button:
- To go from a high speed back to
the first one press twice the button:
- To give power to the lights or to
shut them down press the button:
- To set the timer up press the
button:
14
WORKING