Sirius Satellite Radio SL903-P Mode D'emploi page 13

INSTALLATION
SL903-P e SM903
To avoid any damages remove the grease
filter before proceeding with the installation
pulling the handle and making the filter turn
dawnwards before removing it.
In the model SL903-P, before removing the
grease filter remove the perimetrical panel
turning it downwards as per Fig.1.
Make a hole taking care of the following di-
mensions:
252mm x 649mm for SL903-P 290x700
252mm x 849mm for SL903-P 290x900
500mm x 375mm for SM903 520x400
680mm x 375mm for SM903 700x400
Make attention to consider at least 60mm of
material Around the hole in order to avoid
any damage during the following product in-
stallation phase.
Adjust the position of the lateral springs
making attention of the thickness of the ma-
terial you are using to fix the unit (Fig. 2).
Connect the appliance with the electric
mains.
Insert the unit from below, making sure that the
springs, previously adjusted(Fig. 2), are strong
enough to keep the product fixed (fig. 3);
Insert the four blocking levers and fix them
using the screws, as showed in fig. 4 and fig.5;
Mount the grease filter, Only for SL903-P
model to install the perimetrical panel.
All manuals and user guides at all-guides.com
To avoid any damages remove the grease
filter before proceeding with the installation
pulling the handle and making the filter turn
dawnwards before removing it.
In the model SL903-P, before removing the
grease filter remove the perimetrical panel
turning it downwards as per Fig.1.
Make a hole taking care of the following di-
mensions:
252mm x 649mm for SL EM903-P 290x700
252mm x 849mm for SL EM903-P 290x900
Make attention to consider at least 60mm of
material Around the hole in order to avoid
any damage during the following product in-
stallation phase;
It is possible to select the more convenient air
outlet according to the position required by
the installation (Fig 6).
The panel containing the electrical compo-
nents can be moved on the opposite side in
order to use the front air outlet (Fig.7).
Once the air outlet reductor has been instal-
led on the selcted outlet, connect the hood to
the power supply and insert the power pack
as indicated in Fig.8.
Fix the power pack by using the six screws
supplied, as per Fig. 9.
Mount the grease filter and to install the pe-
rimetrical panel.
13
INSTALLATION
SL EM903-P