Zeegma Zonder Robo Next Manuel De L'utilisateur page 10

3.
EN
When charging, do not fix the water tank in the product to make sure the charging is safe.
4.
The device contains batteries that should only be replaced by a qualified person. In case of
problems with the battery, contact an authorized service center.
Description of vacuuming modes and functions:
1.
1. Automatic vacuuming: activate the main switch of the product. When the control
light goes on, the product is active. Press start/pause key on the cleaner or remote
control and the cleaner will start vacuuming automatically.
2.
Spot vacuuming: press the spot vacuuming on the remote control to start cleaning.
3.
Edge vacuuming: press the edge vacuuming key on the remote control to start cleaning.
4.
Manual control: use remote control keys to choose direction of cleaner's movements
(forward, backward, left and right).
5.
Suction power adjustment" in automatic vacuuming mode, press suction power
adjustment key on the remote control or in the application to adjust the suction power.
Suction power adjustment works only in the automatic vacuuming mode.
Options:
•
Pause: when the cleaner operates, press start/pause key on the cleaner, remote control
or in the application to stop its operation.
•
„Wake up": The cleaner will go to sleep if it remains inactive for 10 minutes. To „wake
it up", press any key on the cleaner, remote control or in the application.
•
Deactivation: to switch the cleaner off, press start/pause key and hold for a couple of
seconds or deactivate the main switch on the product.
•
When the work is done, direct the vacuum cleaner into the docking station to charge it.
4a. How to install the water tank:
Description of parts (see fig. 5)
How to use the water tank (see fig. 11 )
1.
Open the tank and pour water into the water inlet hole.
2.
Close the water tank and fix the mop on the dedicated external surface.
3.
Fix the water tank and dustbin and install in the cleaner.
4.
Press the start/pause key to make the cleaner start wet-cleaning.
How to clean and empty the water tank and mop (see fig. 12):
1.
Remove the water tank.
2.
Pour water out of the tank.