Programming Of Heating Profiles - Alpha IP WTHP 61001 Serie Mode D'emploi

Operating modes and configuration
2. Select the symbol " " and confirm the selection by shortly pressing the setting
wheel.
3. Select "ON" by turning the wheel in order to activate the operation lock, or "OFF"
in order to deactivate the operation lock. Confirm the selection by pressing the
wheel shortly.

6.1.5 Programming of heating profiles

This menu item allows to make settings for heating or cooling profiles and the cre-
ation of week profiles according to own requirements.
1. Press and hold the setting wheel (E) in order to open the configuration menu.
2. Select the symbol "
wheel.The following subordinate menu items are available in the menu, to be
accessed by turning the wheel:
"type" for switching over the base station between the modes Heating and Cool-
ing. (deactivated when multi-IO box is connected)
1. Turn the setting wheel (E) to "HEAT" for heating or "COOL" for cooling and con-
firm by shortly pressing the wheel.
"Pr.nr" for the selection of the week profile number ("no. 1, no. 2 ... no. 6").
1. Select the number of the desired profile and confirm the selection by shortly
pressing the setting wheel.
48
" and confirm the selection by shortly pressing the setting