PRO-POINT 8381659 Manuel De L'utilisateur page 7

8381659
6. In the event that it becomes necessary to store the tool for an extended period of time
(overnight, weekend, etc.), it should receive a generous amount of lubrication at that
time. The tool should be run for approximately 30 seconds to ensure oil has been evenly
distributed throughout the tool. The tool should be stored in a clean and dry environment.
WARNING! NEVER use a penetrating oil to clean or lubricate your air tool. Penetrating oil is a
solvent that will break down the internal grease and cause the air tool to seize up.
DISPOSING OF THE TOOL
If your tool has become damaged beyond repair, do not throw it out. Bring it to the appropriate
recycling facility.
TROUBLE SHOOTING
Problem(s)
Tool runs at normal
speed but loses power
under load.
Tool runs slowly.
Air flows slightly
from exhaust.
Tools will not run. Air
flows freely
from exhaust.
Tool will not
shut off.
Loss of power or
erratic performance.
Visit www.princessauto.com for more information
3/4 in. x 20-1/2 in. Belt Sander
Possible cause(s)
Motor parts worn.
Lack of air tool oil.
Motor parts jammed with dirt
particles.Air flow blocked
by dirt.
Excessive air tool oil in
tool or build up of
shipping grease.
O-rings throttle valve
dislodged from seat
inlet valve.
Damage to, or excessive
wearing of internal parts
O-rings throttle valve
dislodged from seat
inlet valve.
Excessive drain on the air
line. Moisture or restriction in
the air hose. Incorrect size or
type of hose connectors.
Air compressor has
insufficient flow.
Note: Repairs should be carried out by a qualified person
Suggested solution(s)
Have a qualified technician replace
worn parts.
Pour air tool oil into air inlet
per instructions.
1. Check air inlet filter for blockage.
2. Pour air tool oil into air inlet as
per instructions.
3. Operate tool in short bursts quickly
reversing rotation back and forth
where applicable.
4. Disconnect supply. Free motor by
rotating drive shank manually
where applicable
5. Repeat above as needed. If this fails,
bring to service center.
Run tool under no load for short periods
of time until exhaust clears.
Have a qualified technician replace
the O-ring.
Bring to service centre
Have a qualified technician replace
the O-ring.
Check the air supply. Ensure tool is
connected to a 3/8 in. I.D. or
larger air hose with no kinks or
restrictions and that the fittings are
connected properly.
Ensure tool is connected to a compressor
whose rated flow matches the tool.
V 3.01
7