PRO-POINT 8381659 Manuel De L'utilisateur page 4

V 3.01
AIR TOOL PRECAUTIONS
1. Extended exposure to air tool noise may cause hearing loss. Ear protection gear can reduce
or eliminate the noise level.
2. Inspect the tool's airline for cracks, fraying or other faults before each use. Discontinue use if
the airline is damaged or hissing is heard from the airline or connectors, while operating the
tool. Replace the defective component/airline.
3. Do not allow people, mobile equipment or vehicles to pass over the unprotected airline.
Position the airline away from high traffic areas, in a reinforced conduit or place planks on
both sides of the airline to create a protective trench.
4. Prevent damage to the airline by observing the following:
a. Never carry the tool by the airline.
b. Keep the airline behind the tool and out of the tool's work path.
c. Keep the airline away from heat, oil, sharp edges or moving parts.
d. Do not wrap the airline around the tool as sharp edges may pierce or crack the airline.
Coil the airline when storing.
5. A damaged or disconnected airline under pressure may whip around and inflict personal
injury or damage the work area. Secure the compressor's airline to a fixed or permanent
structure with clamps or cable ties.
6. Install an in-line shutoff valve or regulator to allow immediate control over the air supply in an
emergency, even if a hose is ruptured.
TOOL USE AND CARE
1. Use the right tool for the job. Do not attempt to force a small tool or attachment to do the
work of a larger industrial tool. The tool will perform better and more safely at the task
for which it was intended. Do not modify this tool or use for a purpose for which it was
not designed.
2. Securely hold this tool using both hands. Using tools with only one hand can result in loss
of control.
3. Maintain tools with care. Keep tools clean and in good condition for a better and safer
performance. Follow instructions for lubricating and changing accessories. Inspect tool
fittings, alignment and hoses periodically and, if damaged, have them repaired by an
authorized technician or replaced. The handles must be kept clean, dry and free from oil and
grease at all times. A properly maintained tool reduces the risk of binding and is easier to
control. Sharp tools are safer than tools which have become dull because you do not have
to apply excessive amounts of force to make your cuts. Applying excessive force can lead to
slips and damage to your work or personal injury.
4. Remove adjusting keys and wrenches. Check that keys and adjusting wrenches are removed
from the tool or machine before connecting it. A wrench or key that is left attached to a
rotating part of the tool increases the risk of personal injury.
5. Avoid unintentional starts. Be sure that the switch is in neutral or OFF position when not in
use and before connecting it to any air source. Do not carry the tool with fingers near or on
the switch.
6. Only use the lubricants supplied with the tool or specified by the manufacturer. Other
lubricants may not be suitable and may damage the tool or even make the tool explode.
7. When not in use for an extended period, apply a thin coat of lubricant to the steel parts to
avoid rust.
8. Maintain the label and name plate on the tool. These carry important information. If
unreadable or missing, contact Princess Auto for a replacement.
4
3/4 in. x 20-1/2 in. Belt Sander
For technical questions call 1-800-665-8685
8381659