Transferring Calls - Amplicom NL 200 Mode D'emploi

1. Press and hold the Power button (4) on
the NL200 until the Status LED (3) lights
up blue.
2. A short time later, the Status LED (3)
flashes blue and the NL200 is registered
on the mobile phone.
Switching the NL200 off
1. Press and hold the Power button (4) on
the NL200 until the Status LED (3) no
longer lights up.
Increasing the volume
1. During a call, press and hold the Volume
Up button (5) until the required volume is
set.
2. An acoustic alert signal is issued on
reaching the maximum volume.
Reducing the volume
1. During a call, press and hold the Volume
Down button (6) until the required
volume is set.
2. An acoustic alert signal is issued on
reaching the minimum volume.
Muting the microphone
1.
2.
3.

Transferring calls

You can switch calls between the mobile
phone and NL200 while a call is in progress.
1.
2.
3.
Service−Hotline: Tel. 0844 800 6503
During a call, press the Volume Up and
Volume Down buttons (5 + 6)
simultaneously for two seconds. This
step is confirmed by the NL200 through
an acoustic alert signal.
When the microphone in the NL200 has
been switched off, an acoustic alert
signal is issued every four seconds and
the Status LED (3) flashes three times at
short intervals.
To switch the microphone in the NL200
back on, press the Volume Up
button (5). This step is confirmed by the
NL200 through an acoustic alert signal.
During a call, press and hold the Volume
Up button (5) for two seconds.
The call is then transferred to the mobile
phone.
To transfer the call back to the NL200,
press and hold the Volume Up button (5)
for two seconds again.
Using the NL200
15