DreamLED SPL-500 Manuel D'instructions page 5

OPERATION
The SPL-500 has 2 lighting modes, which can be selected using the ON/OFF button.
1. SENSOR ACTIVATED LIGHTING MODE
Press the ON/OFF button 1x to activate the lamp.
A. Battery capacity is higher than 30%
The lamp will turn ON automatically at night (<30 LUX) at full light (100%) when motion
is detected in the detection range. About 25 seconds after the last motion has been
detected the lamp turns to 3% of full light and keeps on working till the morning time or
till the battery is empty.
B. Battery capacity is less than 30%
The lamp will turn ON automatically at night (<30 LUX) at full light (100%) when motion
is detected in the detection range. About 25 seconds after the last motion has been
detected the lamp turns OFF.
2. CONTINUOUS LIGHTING MODE
Press the ON/OFF button FOR 3 SECONDS to activate the lamp. The lamp will turn ON
automatically. Motion and light sensors are now disabled. The lamp will be continuously
ON until the battery is empty.
-5-