Cleaning And Maintenance Of The Oven's Front Door Glass; Catalytic Walls - Teka FS 603 4VE SS Mode D'emploi

Cleaning And Maintenance Of The Oven's Front Door Glass

Remove the profile by pressing the plastic latches on both left and
right sides as shown in figure 4 and pulling the profile towards yourself
as shown in figure 5. Then remove the inner-glass as shown in figure 6.
If required, middle glass can be removed in the same way. After cleaning
and maintenance are done, remount the glasses and the profile in reverse
order. Make sure the profile is properly seated in its place.
Figure 4

Catalytic Walls *

Catalytic walls are located on the left
and the right side of cavity under the
guides. Catalytic walls banish the bad
smell and obtain the best performance
from the cooker. Catalytic walls also
absorb oil residue and clean your oven
while it's operating.
Removing the catalytic walls
In order to remove the catalytic walls; the guides must be pulled out.
As soon as the guides are pulled out, the catalytic walls will be released
automatically. The catalytic walls must be changed after 2-3 years.
Figure 5
Figure 7
31
2
1
Figure 6