Panel Description; Installation; Using The Balance - METRICA YPB 100-001 Mode D'emploi

III. Panel Description
Panel Explanation
1.
ON/OFF: Turns device on and off
2.
UNIT select : kg, ct, T, TAR, dr, PKT, GN, TMR,
gsm, tlJ, mo, dwt, oz, lb, tlT, ozt, tlH, %,g
3.
COU: Piece counting mode
4.
TARE/CAL:Tare the balance/ Calibration key
YPB Models • All Rights Reserved •
www.labbox.com
IV. Installation
Choosing the installation location
The location should meet the following conditions:
1.
Work room should be clean and dry
2.
Balance should be placed on a solid, stable, plain flat surface
3.
Avoid locations in which the balance could be exposed to any of
the following:
a.
Airflow from air conditioners, fans, doors, or windows
b.
Vibrations from surrounding or nearby equipment
c.
Direct sunlight or radiation
4.
Do not use the balance anywhere exposed to explosive, combus-
tible, or corrosive gases.
5.
Do not use the balance in areas with high humidity or high levels of
dust
6.
Keep the balance clean.
7.
Do not leave material on the balance when not in use.
Unpacking and inspection
Check that all of the items indicated below are included in the package
and that nothing has been damaged:
•
Balance
•
Weight
•
Power Cable
•
Manual
In case the balance or any component is damaged during transport, tell
your transportation agent immediately in order to process claims within the
proper time frame.
V. Using the Balance
Start
Connect the balance to the power supply and press ON key on the panel.
1.
Wait 30 minutes after powering on for best performance.
After warming up, calibrate the balance.
2.
After calibration, the balance will enter weighing mode
3.
To turn the balance off, press the OFF key on the panel and the display will shut
4.
off. If the balance will be unused for an extended period of time, disconnect it
from the power supply
YPB Models • All Rights Reserved •
www.labbox.com