Getting Started - Furrion FDHS32M4A Manuel D'instructions

Getting Started

The Setup Wizard window appears the first
time you turned on the TV. It will assist you
to configure the TV and scan for available
channels.
IMPORTANT: Make sure the antenna or
cable TV system connection is made.
1. Press POWER button on the TV control
panel or button on the remote control
to switch on the TV. The power indicator
will change to green. The Setup Wizard
window appears on the screen.
NOTE: It may take a few seconds before
the Setup Wizard window appears on the
screen.
key to highlight TV Location,
2. Use or
then press
or
Store Mode.
NOTE: When you select Store Mode it
will remind you Store Mode consumes
more energy. Select Yes to enter or No to
cancel.
to highlight Go to next
Press or
step, press OK or
3. Use or key to highlight Menu
Language, then press
desired language.
Press or to highlight Go to next
step, press OK or
to select Home Mode or
to go to the next step.
to select the
or
to go to the next step.
4. Use or key to highlight Time Zone,
then press to select desired time zone.
or
Use or key to highlight Daylight
Saving Time, then press
On or Off.
key to highlight Time Format,
Use or
then press
or
24-hour.
Press or to highlight Go to next step,
press OK or to go to the next step.
5. Use or key to highlight Air/Cable,
then press
or
base on your connection.
to highlight Go to next
Press or
step, press OK or
The Setup Wizard will scan for available
channels automatically. The scanning may
take some time.
to select
or
to select 12-hour or
to select Air or Cable
to start the auto scan.
15