Machine Assembly; Instructions For Mounting Handles And Belt Guard; Instructions For Installing Cable; Machine Inspection - Ridgid Kollmann K-750R Mode D'emploi

Kollmann
Figure 3 – T-406 Spade Cutter: Used to get soft grease
or debris moving in the drain.
Figure 4 – T-411 2", T-413 3" & T-414 4" Cutter: Used for
general cleaning to remove tree roots and
materials clinging to pipe walls.

Machine Assembly

WARNING
To prevent serious injury, proper assembly of the
Drain Cleaner is required. The following proce-
dures should be followed:
Instructions For Mounting Handles and
Belt Guard
Handles – Assemble handles to machine frame and
secure with two (2) belt guard screws.
Belt Guard – Check the belt guard to ensure that it is
approximately 1 / " from the drum. Reposition guard if
4
necessary and tighten bolts (Figure 5).
WARNING Gap between belt guard and drum
should not exceed 1 / " to prevent fingers being caught
2
between belt and pulley. Do not operate machine with-
out belt guard.
K-750R 5 / " Cage Machine
8
Ridge Tool Company

Instructions For Installing Cable

Do not remove bands or staples from
CAUTION
cable shipping carton. Cable is under tension and will
whip causing injury.
Retrieve end of cable through the center hole of carton and
remove enough cable to connect with drum pigtail. Connect
to pigtail by sliding cable couplings together and turning
screwdriver slot in coupler 180°. Couplings are in locked
position when hash mark is on opposite side of screwdriver
slot as shown in Figure 5. Manually feed cable into drum.
QUICK-CONNECT CABLE & TOOLS
Rotate pin one-half turn in either direction to
quickly add cable or tools.
Screwdriver Slot
LOCKED
Hash mark CLOSED aligned with L stamped on coupling.
Hash Mark
(Un-locked position)
UNLOCKED
Hash mark OPEN aligned opposite L stamped on coupling.
Coupling features stainless steel pin and spring: eliminates need for
punches, stands, or expansion pins.
Figure 5 – Disconnecting/Connecting Cable or Tool

Machine Inspection

WARNING
To prevent serious injury, inspect your Drain
Cleaning Machine. The following inspection pro-
cedures should be performed before each use.
1. Make sure the Drain Cleaning Machine is unplugged
and the directional switch is set to the OFF position
(Figure 6).
Hash Mark
(Locked position)
Screwdriver Slot
5