Description, Specifications And Standard Equipment Description; Specifications; Standard Equipment - Ridgid Kollmann K-750R Mode D'emploi

Kollmann
• Do not operate machine if operator or machine is
standing in water. Will increase the risk of electrical
shock.
• Wear safety glasses and rubber soled, non-slip
shoes. Use of this safety equipment may prevent seri-
ous injury.
• Only use the K-750R to clean drain lines 3" to 6" in
diameter. Follow instructions on the use of the
machine. Other uses or modifying the drain cleaner for
other applications may increase the risk of injury.
Description, Specifications and

Standard Equipment

Description
The RIDGID/Kollmann K-750R Drain Cleaning Machine
will clean drain lines 3" to 6" in diameter and 100 feet in
length. It is specifically designed with a steel wire drum to
allow for inspection and cleaning of the cable.
The steel wire drum is belt-driven by a
motor that has a grounded electrical system. An integral
Ground Fault Interrupter (GFCI) is built into the line cord
and a "kickstand" base is provided for machine stability
during operation. A pneumatic foot actuator provides
ON/OFF control of the motor.
The drum powers a 5 / " inner core cable that has a quick
8
change coupling system for connecting or disconnecting
tools. The cable is manually fed in and out of the drain. An
integral torque limiter will cause the drum to stop rotating
whenever excessive torque is created when the cutting tool
attached to the cable hits a snag and stops rotating.

Specifications

Line Capacity ...............3" – 6" Lines, Up To 100 feet
Drum Capacity .............100' of
Motor Type...................115V, Reversible, Single
Rating............................
Amps............................6.5
Weight
(Machine & Cable) ........194 lbs.
Length..........................26"
Width............................21"
Height ..........................43"
4
K-750R 5 / " Cage Machine
8
1 / HP electric
2
5 / " Cable
8
Phase, AC (60Hz)
1 / HP @ 1725 RPM
2
Standard Features
K-750R
• K-750R Cage Machine (Figure 1)
• C-24 IW Solid Core Cable (Integral Wound)
( 5 / " x 100')
8
• 1 Pair Gloves
• T-403 P-Trap Cutter (Figure 2)
• T-406 Spade Cutter (Figure 3)
• T-411 2" Cutter (Figure 4)
• T-413 3" Cutter (Figure 4)
• T-414 4" Cutter (Figure 4)
• Safety & Instruction Card
• Rental Checklist Card
• Instruction Video
• Toolbox
Figure 1 – Machine With Gloves
Figure 2 – T-403 3" P-Trap Cutter: Used for exploring
and breaking up stoppages.
Ridge Tool Company